佳能BJC-80维修模式

佳能BJC-80
EEPROM清除:
1.按住POWER和RESUME键,插电源线,初始化后手松开.
2.按住RESUME和CARTRIDGE键,按POWER键,直到听到1长1短的蜂鸣后.
3.根据下表,按CARTRIDGE,设置相应的废墨量.
4.按RESUM键,设置相应的废墨量.
5.用POWER键关机
(如果为25%,50%或75%,要用POWER键开机.如果为0%,要用POWER键开机,然后拔掉电源线)
按CARTRIDGE次数:                                                默认设置:
7次                                                             0%
16次                                                            25%
15次                                                            50%
14次                                                            75%